DiagBox 7.04 Peugeot 307 Interface Problems
 

Hello guys,

i own a Peugeot 307 SW 1.6 Gasoline Year: 2005. I want to read out my faults so i bought a chinese Interface.

Here starts the problems.

My interface has:
Firmware 4.3.0
Serial 963830 B/ Peugeot

I tryed Diagbox 7.04 but i cannot communitcate with the car. So i start to read in the net about it. I found some people that say with a B/ in your Serial you maybe blacklisted in Diagbox Version later than 5.29 is this right?

Can someone help me with my problem and the interface or give me some tips what can i check or what should i do to get a connection to my car.

P.S. I came to the point where the Software ask for DAM Number. I use the Number from my Tyrepressure Sticker on my driver door. I hope that is the right number. But i got alyways the message cannot communicate with the chip.

greetings Troll

Hi guy,

Your interface must be flash and after you go to work with diagbox 7.XX.
Two ways to flash your interface:
by software: contact nlc (member) by pm
by hardware: flash SPI and MCU MB90F546GS with universal and ISP prog!

Regards.

Ok thats a point to think about.

Can i get Diagbox 5.29 anywere?
I want to try if the interface work or not.

I try to write nlc a pm and ask him for help...when i find the user nlc :15:

With lexia3 V45 or PP2000 it's better for try interface for me !

Regards.

So you think i should give PP2000 a try?
Without DiagBox?

yes, without diagbox on CAN VAN and full CAN vehicles !

Regards

Certaines interfaces xs evolution chinoises ne fonctionnent pas sur les 307 ou C5, ton interface est peut etre de mauvaise qualité

Right now i tryed Diagbox 5.29 before i try PP2000 i cannot connect to my car.

Which version of PP2000 or lexia should i use to try.
I my softwarebox there would be no point that say CAN and VAN communication.

dont try any more if it doesnt work with pp2000 , forget it and you have to take an other one :banghead:

Yes this is the only way send this back to the seller.

Good decision !

And see you soon, for a return of your diag with new interface....

@++