Tlemcen Car electronics - Afficher un message

Simple · 20/02/2016, 23h07

I have tried Google translation, but it is not very clear, I am not sure I understand where is your problem..
However.. after you rename APP to APP7 and AWRoot to AWRoot7 and starting V8.01 installation, it remove (DiagBox 7) information but NOT the application and it will start DiagBox v8.01 installation (demande de desinstaller ancienne version et pas nom d utilisateur mot de passe, this is ok continue installation).

Installation will start and when it stops (because of registration) close it and stop services again and rename AWRoot ONLY (point #3).. and continue...

Important.. Do not forget to copy the files (listed in the attachment) from DiagBox 7..

20/02/2016, 23h07	#6
Simple Membre attaché Date d'inscription: août 2014 Localisation: NA Messages: 279 Thanks: 5 Thanked 414 Times in 80 Posts Pouvoir de réputation: 20	I have tried Google translation, but it is not very clear, I am not sure I understand where is your problem.. However.. after you rename APP to APP7 and AWRoot to AWRoot7 and starting V8.01 installation, it remove (DiagBox 7) information but NOT the application and it will start DiagBox v8.01 installation (demande de desinstaller ancienne version et pas nom d utilisateur mot de passe, this is ok continue installation). Installation will start and when it stops (because of registration) close it and stop services again and rename AWRoot ONLY (point #3).. and continue... Important.. Do not forget to copy the files (listed in the attachment) from DiagBox 7..