I searched for a animal bit mark on the wires. I check the wire bundle for any damage but i cannot find something. My China Diag Interface do not read the ecu complete. I cannot see the manufactor brand and the version in the program. I checked all the funktion with my diag, the valves, rpm speed of the diffrent parts in the gearbox. But i cannot find something. In the last days the main problem is the ecu would not detected and is not working, so i cannot switch gears the lever stuck on P and the savety switch that goes open when i push the brake padle doing nothing. The BSI alert shows me a ESP/ASP fault and the engine shows a few faulst to because there are no signal and data from the gearbox ecu.
Where can i find software for my ecu? And can i flash this by myself?
|