02/02/2024, 17h08 | #1 |
Débutant
Date d'inscription: février 2024
Localisation: France,lille
Âge: 31
Messages: 10
Thanks: 11
Thanked 8 Times in 3 Posts
Pouvoir de réputation: 0 |
Probleme DDE+DME emetteur
Bonjour ,
J'ai une 318d e91 année 2007 qui n'a plus démarrée du jour au lendemain . J'ai passé un diag , plusieurs codes defaut s'affichent tous en rapport avec le DDE DME , module auquel je n'arrive pas acceder avec le diag . Le CAS est aussi en defaut . Je soupconne une panne d'alimentation electrique je recherche donc les schemas electriques de la voiture pour savoir quel fusibles et quel relais je dois tester . Je precise que j'ai déjà bien cherché sur le net . Si quelqu'un aurait ces schemas se serait super ! Merci . |
02/02/2024, 18h42 | #2 |
Membre habitué T-E
Date d'inscription: février 2021
Localisation: Montpellier
Âge: 34
Messages: 171
Thanks: 266
Thanked 183 Times in 70 Posts
Pouvoir de réputation: 5 |
Salut tu as quoi en code defaut
|
02/02/2024, 23h24 | #3 | |
Membre Non Confirmé
Date d'inscription: février 2024
Localisation: Polska, Zabrze
Âge: 31
Messages: 6
Thanks: 5
Thanked 5 Times in 4 Posts
Pouvoir de réputation: 0 |
Open the hood of the car and remove the cover on the left side of the windshield.
The engine controller is located there. Disconnect the cable harness and check the connector to see if power is reaching the controller when the ignition is on. I suspect you have msv70. If not, look for another diagram on the Internet. If the voltage is there, but too low, I would look for a ground problem. it is probably a brown cable near the positive terminal under the engine hood, it may even enter it from the bottom. ---------- Post added at 23h24 ---------- Previous post was at 23h23 ---------- Citation:
https://files.fm/u/3fcb7q8xpk |
|
03/02/2024, 06h01 | #4 |
TE-MANIA
Date d'inscription: janvier 2013
Localisation: Frejus
Messages: 10 309
Thanks: 12 778
Thanked 18 444 Times in 6 633 Posts
Pouvoir de réputation: 237 |
Salut. Déjà pour les fusible c est 3 secondes de recherches sur Google lol
https://fuse-box.info/bmw/bmw-3-seri...-and-relay/amp
__________________
"Il vaut mieux être détesté pour ce que tu es, plutôt qu’être aimé pour ce que tu n’es pas" |
The Following 3 Users Say Thank You to jah83 For This Useful Post: |
03/02/2024, 12h16 | #5 | |
Débutant
Date d'inscription: février 2024
Localisation: France,lille
Âge: 31
Messages: 10
Thanks: 11
Thanked 8 Times in 3 Posts
Pouvoir de réputation: 0 |
Salut .
Déja j'ai cherché LOL . Jai testé les fusibles dans le compartiment moteur, ceux sur le boitier de distribution sur la batterie , je suis en train de tester les relais maintenant . Ensuite , j'ai trouvé les pages relatant la gestion d'alimentation BMW ainsi que ceux des fusibles . Cela fait deux semaines que je cherche sur le net et que j'essaie multitude de solutions J'ai demandé si quelqu'un avait les schemas complets , je n'ai pas demandé à avoir un tuto " recherche sur le net" ni a ---------- Post added at 13h16 ---------- Previous post was at 13h13 ---------- Citation:
Déja j'ai cherché LOL . Jai testé les fusibles dans le compartiment moteur, ceux sur le boitier de distribution sur la batterie , je suis en train de tester les relais maintenant . Ensuite , j'ai DEJA trouvé les pages relatant la gestion d'alimentation BMW ainsi que ceux des fusibles . Cela fait deux semaines que je cherche sur le net et que j'essaie multitude de solutions J'ai demandé si quelqu'un avait les schémas complets , je n'ai pas demandé à avoir un tuto " recherche sur le net" ni à être rappeler a l'ordre . En revanche , si tu as les schémas , je veux bien . :) ( Si un modo peut supp mon msg au dessus , je l'ai envoyé par inadvertance ^^ ) |
|
03/02/2024, 12h28 | #6 | |
Membre Non Confirmé
Date d'inscription: février 2024
Localisation: Polska, Zabrze
Âge: 31
Messages: 6
Thanks: 5
Thanked 5 Times in 4 Posts
Pouvoir de réputation: 0 |
And here I will surprise you, not every electronics failure is the fault of a fuse, and fuse diagrams sometimes do not match reality. For example, all diagrams showed that I had 4 fuses at DME, but I did not have them. Other people on YouTube also had these fuses, with the same engine and year +/- 1 year. I have all the fuses behind the glove box. I have the original harness without any modifications, but it is best to start with the fuses. This is the fastest and easiest way.
I had the same problem in e90 n43b20 and all fuses were good. The culprit was the ground from the controller. ---------- Post added at 12h28 ---------- Previous post was at 12h26 ---------- Citation:
|
|
The Following User Says Thank You to Zabrzanin94 For This Useful Post: | rapou30 (03/02/2024) |
03/02/2024, 12h40 | #7 |
Membre Non Confirmé
Date d'inscription: février 2024
Localisation: Polska, Zabrze
Âge: 31
Messages: 6
Thanks: 5
Thanked 5 Times in 4 Posts
Pouvoir de réputation: 0 |
The mass marked with a blue arrow is now screwed in a different place. It should be screwed under the plastic of the positive terminal (there is a ground there), but suddenly it stopped connecting. So I screwed it to a different place. The voltage on the DME plug was around 4v-5v instead of 12v.
I have a different engine, but I had the same problem. The structure should also be similar. Zdjęcie: https://files.fm/u/pu6mv9sxx5 |
The Following User Says Thank You to Zabrzanin94 For This Useful Post: | icee (03/02/2024) |
03/02/2024, 13h02 | #8 |
Débutant
Date d'inscription: février 2024
Localisation: France,lille
Âge: 31
Messages: 10
Thanks: 11
Thanked 8 Times in 3 Posts
Pouvoir de réputation: 0 |
|
03/02/2024, 18h44 | #9 |
TE-MANIA
Date d'inscription: janvier 2013
Localisation: Frejus
Messages: 10 309
Thanks: 12 778
Thanked 18 444 Times in 6 633 Posts
Pouvoir de réputation: 237 |
Oui bien sur, envoi les 7 derniers caractère du vin
__________________
"Il vaut mieux être détesté pour ce que tu es, plutôt qu’être aimé pour ce que tu n’es pas" |
The Following User Says Thank You to jah83 For This Useful Post: | icee (10/02/2024) |
03/02/2024, 19h44 | #10 |
Membre Non Confirmé
Date d'inscription: février 2024
Localisation: Polska, Zabrze
Âge: 31
Messages: 6
Thanks: 5
Thanked 5 Times in 4 Posts
Pouvoir de réputation: 0 |
Get to the DDE controller, it is under the hood of the car on the left side, on the windshield (when you are facing the car).
Unplug the plug and check the pins to see if there is 12v on the plug when the ignition is on. This may be an issue with the weight of the controller itself. If you have 12v on the pins, the controller is damaged. If it is below 12v, the problem is the ground cable going from the controller to the body. In my first post on the topic, you have a link to a photo of the pins and you need to connect these pins with a multimeter from the side of the cube. And in the second one I have added a photo of the cable I am talking about and what problem I had. Of course, close everything tightly again later. Also make sure that there is no water under the controller in the box in which it is mounted. Because I have already seen cases where such things happened. Generally, these controllers tend to get damaged when simply replacing the battery. |
10/02/2024, 19h49 | #11 |
Débutant
Date d'inscription: février 2024
Localisation: France,lille
Âge: 31
Messages: 10
Thanks: 11
Thanked 8 Times in 3 Posts
Pouvoir de réputation: 0 |
VIN : K005803
J'ai testé le relais bleu DME et les fusibles juste après : RAS Le 12v arrive bien aux broches du calculo . Ce que je ne comprend pas c'est que la pompe a carburant tourne très fortement quand je mets le contact alors que avant ce problème je ne l'entendais jamais . J'ai aussi le voyant DSC qui est allumé . Est ce que quelqu'un sait ou je peux trouver ISTA svp ? |
11/02/2024, 07h24 | #12 |
Genious T-E
Date d'inscription: décembre 2013
Localisation: France, Clermont Ferrand (63)
Messages: 3 604
Thanks: 4 036
Thanked 5 376 Times in 2 627 Posts
Pouvoir de réputation: 74 |
Salut,
Tu as quoi comme interface pour ton diag ? Tu t'étais déjà connecté avec sur ta E91 ? Ensemble des masses en état ? |
The Following User Says Thank You to Pilouf For This Useful Post: | icee (12/02/2024) |
11/02/2024, 12h08 | #13 |
Membre trés attaché
Date d'inscription: décembre 2018
Localisation: france,charleville mezieres
Âge: 49
Messages: 586
Thanks: 548
Thanked 1 293 Times in 429 Posts
Pouvoir de réputation: 19 |
salut tous le monde utilise autocom ou dephi pour le diag mais pas fiable pour les bmw et mini c mieux d installer ista il ya même les schémas électrique
|
12/02/2024, 05h58 | #14 |
TE-MANIA
Date d'inscription: janvier 2013
Localisation: Frejus
Messages: 10 309
Thanks: 12 778
Thanked 18 444 Times in 6 633 Posts
Pouvoir de réputation: 237 |
Oui t inquietes il sait, il 1 fait les recherches sur internet ! Il a besoin de personne pour ça !
__________________
"Il vaut mieux être détesté pour ce que tu es, plutôt qu’être aimé pour ce que tu n’es pas" |
12/02/2024, 06h19 | #15 | |
Membre habitué T-E
Date d'inscription: décembre 2023
Localisation: Occitanie
Âge: 35
Messages: 125
Thanks: 63
Thanked 101 Times in 53 Posts
Pouvoir de réputation: 2 |
Citation:
ICEE: Tu n'as pas une merde avec ton câbe ibs ? Envoyé de mon SM-S911B en utilisant Tapatalk
__________________
A+ |
|
The Following User Says Thank You to skygui For This Useful Post: | icee (12/02/2024) |
Sponsored Link |
Liens sociaux |
|
|
Discussions similaires | ||||
Discussion | Auteur | Forum | Réponses | Dernier message |
emetteur ou recepteur HS trafic D 1998. | curieux | Transponder, code pin | 12 | 10/12/2020 12h16 |
Recherche émetteur récepteur embrayage espace 3 | progdebutant | Vente, Achat, Echange | 11 | 12/11/2019 15h20 |
Vends emetteur clé pour 107/C1 | barthdu22 | Vente, Achat, Echange | 2 | 27/04/2019 11h28 |
Question émetteur altea | akasa67 | Transponder, code pin | 3 | 27/03/2019 18h30 |
emetteur embrayage neuf casse a repetition | jpay2 | Fiat, Alfaromeo, Lancia | 19 | 14/03/2016 19h51 |