zenec-mc2000 vw

[skens]

hi
please connect point for zenec-mc2000 vw
radio is not for me, but be prepared!
i have beeprog+

I see that they can connect with a cable ISP

thx

[PIC16F84]

hello friend


in beeprog+ select your device by isp adapter and presse button ISP

[skens]

hi
I saw it, I was just wondering whether the car radio connection point
thx
regards

[skens]

hi
can someone tell me how to do a project for atmel in x-prog!
or beeprog+ via isp or isp-jtag
i connect but, comunication error
Can you explain to me how to read at 1280?????
thx

[skens]

hi
xprog write : incorect device ID
Description of ISP connector pins:1280 isp
VCC check only pin 10
PB1(SCK) pin 20
PB3(MISO) pin 22
PB2(MOSI) pin 21
RESET\ pin 30
GND (VSS) pin 11
where i mistake???
thx

[PIC16F84]

hello

Pinout ATmega128 (TQFP 64)

(SCK) PB1 pin11
(MOSI) PB2 pin12
(MISO) PB3 pin13
(RESET) pin20
(GND) pin22\53\63

remove the vcc wire from pcb power on (12v) and try this one

good luck

[skens]

hi
i need good dump flash
ZE-MC2000.Atmega1280.V1.49.Feb 27 2009.09

thx

[skens]

hi
i need good flash for zenec 2000 atmega 1280!
this is my,but After restoring the original dumps worked just lights up! the display only ZENEC
maybe need restart,how?

i need good dump flash
ZE-MC2000.Atmega1280.V1.49.Feb 27 2009.09

[one-man-show]

Merci frere

[skens]

hi
i not solved


i need good flash for zenec 2000 atmega 1280!
this is my,but After restoring the original dumps worked just lights up! the display only ZENEC
maybe need restart,how?

i need good dump flash
ZE-MC2000.Atmega1280.V1.49.Feb 27 2009.09