clone DDCR

[costinet]

Hello everyone. I have a question about ecu compatibility between a ecu ddcr mounted in a renault megane 2 1.5 dci euro3 and a ecu ddcr mounted in a renault clio 1.5 dci euro3. It's possible to be replaced, after rewrite the software? I have original ECU from megane II with this serial nr.:8200334419 , 8200340926 , DDCR R0410B024A , SERIAL No80975965 JWG and the ecu from clio have this serials : 8200334540 , 8200412768, DDCR R041B026C , SERIAL No 82436926 JXG
Thank you.

[nas33]

salu ecu clio ddcr et megane ddcr ne sont pas compatible .ecu ddcr megane eeprom atmel 95080 et l autre clio 95080

[costinet]

k .merci beaucoup.
another question : i found another ecu with same HW serial like original.it's possible to clone the ecu only on obd connector, or must cut the plastic case for desoldering and read eeprom to clone IMMO? i have fgtech galleto v45 china clone, mpps v16 and fg galletto 1260. the new ecu have same proprieties like old ecu, same power 82hp, but i make a chiptunning on mine ecu.

[nas33]

non il faut dessouder eeprpm et la ressouder

[costinet]

thank you...best regards

[machin76]

non il faut dessouder eeprpm et la ressouder

je confirme

[costinet]

hello guys. i come back with another question and request to help: can anyone to tell me how virginize this ecu? i read some forum , and i see this tips:

Can be done ONLY virgin Delphy DDCR ecu.
On the 95080 flash, : >

Put line 0000 : all 16 bytes to FF AND
line 0001 : first 9 bytes to FF,

and this is virgin. Use emu or recode ecu by original uch and keys as you wish

100 % guaranteed solution, virginised those ecus many, many times !

so....any advise?!

[adel2789]

post the original dump i will do it
best regards

[conan981]

it is right, only virgin. but you can use immo emulator like julie or similar if you need immo off after virginizing

[akasa67]

Slt si c'est le même tu fais un vierge tu remet vin code injecteurs..

[sharediag]

bonsoir,
apres plusieurs dessoudage je viens de bousiller la st95080 de DDCR megane 2 1.5 dci de 2003 REF: 8200334419 , 8200340926 , R0410B024A
si qlq1 peut me filer le dump orig
merci d avance.

[sharediag]

ou si qlq1 peut me confirmer si ce dump n est pas corrompu.

[sharediag]

ou un dump fonctionnel pour le calculateur en référence.
merci pour votre aide.

[ducla]

Bonsoir.Comme déjà dit il suffit de virginiser l'eprom (off partout)et ça doit démarrer.Il ne reste plus qu'à remettre le vin et les codes injecteurs pour ne pas avoir de remontée de défauts.

[kaki02]

Ton eeprom soit tu mets tout en fffffffffff eeprom totalement vierge et tu le ressoudes dans ce cas la voiture demarre voyant prechauffage alumé regime moteur 1100rpm et pas d'acceleration tu dois rentrer les code injecteurs.
Deusieme cas virginiser seulement les deux premieres lignes en fffffff tu ressoudes eeprom demarrage directe sans prechauffage
Voila c à vous de choisir ce que tu veux faire

[kaki02]

Same ecu hw and sw :
- U can read original ecu boosted with mpps save it.
- Virgin immo second ecu and confirm that car start normally without problems.
- Write original flash boosted from original ecu to second ecu with obd.

[ZapDus]

I have this ecu with immo off
I can confirm, only with emulator

[danielif]

Hi, i check now read KIA/Hyundai DDCR in BOOT mode by MPPS, and after read in banch by K-Line KESS. No diferences, 1:1 Ok, all identic files.
Only need programm fisicali eeprom.