Diagbox Révérence 921815 /C

[omarzoro]

Bonjour
Mon problème est que je fais une bêtise sur mon interface Diagbox Révérence 921815 /C qui marche bien ; en le flashons avec un fichier révérence 963830 /c et du-cou il naît plus reconnu!
vous n'avez pas le firmware d’origine révérence 921815 /C pour le reflasher svp ?

[Simple]

I tried Google Translate but I am not sure if I understand it properly.

However, if you have a problem with the VCI NOT being recognized after flashing the firmware, it could be due to error during the flashing process. This can be due to:
1- Corrupt Firmware file. (bad file from source or during extraction (unZIP) or download)
2- Corruption in flashing process. (Low or fluctuating voltage or Anti Virus)
3- Problem with the Chip or the device hardware. (Loose connector/cable or bad component affected by cold or heat)

To see if this can be fixed do the following:

1- Download the Firmware again from a different source, like here:
[/URL]
use a Torrent downloader and download only the Firmware. Or from other source.

2- Use a different computer to flash the firmware, and ensure that the computer is connected to the mains (Electricity not Battery). It is possible that the computer USB voltage was at or below the threshold needed for the flashing process.
After flashing is successful, keep the VCI connected to USB for at least 10 seconds before disconnecting the device.

3- If it is bad connection or a faulty chip, then ensure that cables are plugged in properly and do not move them during the flashing process. chip replacement would be necessary, and could be more difficult to fix. I hope this is not the case.

Good luck.

---------- Post added at 07:36 AM ---------- Previous post was at 07:33 AM ----------

[url]http://www.tlemcen-electronic.com/forum/showthread.php?t=64153 (http://www.tlemcen-electronic.com/forum/showthread.php?t=64153)

[omarzoro]

Thank you simple i will try

[omarzoro]

Résolu merci tout le monde

[Simple]

Just for all to know, it was the ACTIA Drivers on Windows that did not recognize the VCI. So a reinstall did the trick.

@omarzoro,
I told you in a post on the other forum this:
https://www.lesamisdudiag.com/diagbox/88755-flash-interface-diagbox-full-ship-921815-c-3.html#post211605
Salam omarzoro,
The Firmware you installed on your VCI should work, if you can communicate with the VCI then uninstall the Drivers and reinstall them. I think it is accidental that it did not work and the problem may be in a connection.


On August 21st.. You see why sometimes we get fed up because the user does not feedback properly..