mc68hc11ph8 reading problem with upa help land rover discovery 2
 

Hey guys, I've been trying to read this MCU on the board with UPA without success. I've unsoldered it and connected it to an adapter without success, and I've used direct cables without success. Any help reading this MCU? I'm desperate.

The problem was that when I ran kilometers on the BCU with Digiprog, the kilometers changed, but the car wouldn't start. I turned off the immobilizer and everything worked. But now the alarm is still activated and the car won't start. I need to read the MCU to extract the alarm PIN and restore the information.